Using Simulink     Search    Help Desk 

Drawing a Branch Line

A branch line is a line that starts from an existing line and carries its signal to the input port of a block. Both the existing line and the branch line carry the same signal. Using branch lines enables you to cause one signal to be carried to more than one block.

In this example, the output of the Product block goes to both the Scope block and the To Workspace block.


To add a branch line, follow these steps:

   1.
Position the pointer on the line where you want the branch line to start.
   2.
While holding down the Ctrl key, press and hold down the left mouse button.
   3.
Drag the pointer to the input port of the target block, then release the mouse button and the Ctrl key.
You can also use the right mouse button instead of holding down the left mouse button and the Ctrl key.


[ Previous | Help Desk | Next ]